Jan 26, 2014

Please note that Cucumber as referenced in this blog is no longer in business. A long time ago I wrote a blog on the Meraki experience Cisco does something “Meraki-lous”. I had my hands on a free Meraki MR12 Wireless Access Point and I was delving into its capabilities. However, with the passage of time … Continue reading How to OpenWRT and Cucumber your Meraki Access Point Buy GL.iNet GL-X750 (Spitz) 4G LTE OpenWrt VPN Router, 128GB Max MicroSD, T-Mobile(EC25-AFFA Module Installed), AC750 Dual-Band Wi-Fi, IoT Gateway, VPN Client and Server: Routers - Amazon.com FREE DELIVERY possible on eligible purchases Search by VIN. Search. Wireguard openwrt client I have a Linksys WR3200ACM with OpenWRT, and the wifi seems pretty slow (slower than other routers like WR54G's etc) - which is odd to start with. However, what's really puzzling me is that I have a tp-link tl-r470t+, and when I connect the DSL and a phone into the tl-r470t+, wired, I can see speeds increase to about 45Mbps down and 20Mbps up. Amazon.com: GL.iNET GL-MT300N-V2 Wireless Mini Portable Travel Router, Mobile Hotspot in Pocket, WiFi Repeater Bridge, Range Extender, OpenVPN Client, 300Mbps High Performance, 128MB RAM: Electronics

How to set up a OpenWRT router as a network client? : openwrt

Configuration of a wifi client in openWrt | Hardware Configuration of a wifi client in openWrt For working with wifi in openWrt there is a script /sbin/wifi. The file /etc/config/wireless is responsible for wifi configuration.

Source To use Wireless Sensors on Openwrt, an agent of sorts is required. The purpose of the agent is to execute on the client (Openwrt) side, to ensure that the needed Wireless Sensor information is returned for SNMP queries (from LibreNMS).

Summary of Wireless Network Client. As shown in figure below is the settings detected automatically. Don't change any thing here, just click Save and Apply button to continue. Restart the router, connect notebook (do not use wireless, must using network cable) to the router. You should able to connect to internet. Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International CC Attribution-Share Alike 4.0 The wireless radio UCI configuration is located in /etc/config/wireless. If the device has ethernet ports, the wireless is turned OFF by default. You can turn it on in /etc/config/wireless by changing option disabled '1' to option disabled '0' (commenting out the line or removing it is sufficient). Configuring OpenWrt as a Routed Wireless Client This page contains an overview on how to configure a LinkSys WRT54GS running OpenWrt as a routed wireless client router. Introductory Information Firstly, be sure to have a look at Matt Kemner's guide to turning the Linksys WRT54G / WRT54GS into an AP-client and routing node. It provides a concise overview on how to configure OpenWrt as a client node, and was invaluable. AP+STA mode allows OpenWrt to connect to a wireless hotspot (AP) and provide wireless access from that hotspot to anything connected to the OpenWrt AP and Ethernet ports, the br-lan device. This assumes that your OpenWrt device has the default settings where the AP and Ethernet port are bridged. I'm trying to set up a "wireless switch" since some of my device have no wlan adapter. I'm using an Asus RT-AC51U flashed with openwrt. Following this guidance I was able to connect the Router as a client to our wlan and also connect a device via cable (using relayd). Unfortunately the speed of the connection is to slow for proper use.